Table of Contents
Advertisement
User Guide
Intelligent Lighting Effects.
It is not recommended to switch intelligent effects (such
as NJD Predator, Datamoon, etc) from the Euro 8s. These
units should be connected directly to the mains supply (via
an isolating switch) and left running all the time that the
installation is switched on. A controller (either a DMX
controller such as Merlin or IQ-MX80, or a remote control
such as AR1) should be used to switch the effects from
operating to standby. This avoids the delay of up to half a
minute caused by the internal electronics performing its
setting up procedure, which happens with all intelligent
motorized lighting effects.
Lighting controllers
A lighting controller such as the NJD SC4000e or
CC4000s may be connected to an output of the Euro 8s
only if the total load connected to the controller does not
exceed the single channel handling capacity of the Euro 8s
(1150W)
The green LED indicates that power is connected to the
unit.
Each push button provides on/off switching of each load.
Push a button so that it latches in to switch on the load
relating to that channel.
Push the button again so that it latches out to switch off
the load relating to that chanel.
The red LED illuminates when the output is on.
© N.J.D. Electronics 2001
OPERATION
Euro 8s
-Page 4-
Advertisement
Table of Contents
