Table of Contents
Advertisement
User Guide
Installer and Users please note:
These instructions should be read carefully and left
with the user of the product for future reference.
The Euro 8s must be installed by a competent
electrician in accordance with the current IEE wiring
regulations.
The Euro 8s is not fitted with a mains plug. This is
because:
i) it is capable of controlling more than 13 Amps
ii) it may be installed permanently
iii) it is an appliance for professional use.
Connect the Euro 8s to the mains supply with the built in
mains lead, Connect the wires as follows:
• Brown = live
• Blue = neutral
• Green/yellow = earth
• The Euro 6s must be earthed
Connect the output loads to the IEC sockets on the rear
panel using IEC plugs. The sockets are directly behind the
switch for each channel.
• For a 15A supply, the maximum total load is 3450W
which can be made up of:
either: 430W watts on each of the eight channels
or: different loads on each channel so that the total
© N.J.D. Electronics 2001
IMPORTANT
Installation
CONNECTION
Euro 8s
-Page 2-
Advertisement
Table of Contents
