Advertisement
Peak Output Power
Accepted Inputs
Hum & Noise
System Gain/Speaker Output
(Measurement made at 1kHz)
Channel EQ (high, low)
SYNC (IN and OUT)
Subwoofer Out
Monitor Out
Phantom Power
Power Requirements
Speakers
Horn
Frequency Response
Subwoofer Crossover
Nominal Impedance
Bluetooth Module Features
Dimensions & Weight
PA2X6BT Specifications
200W
4 ohm load
CH1 and CH2
Mic XLR Balanced, Line Level 1/4" Un-balanced
Ch3
1/8" Line Level or Bluetooth Device
-56dB
Residual Noise, all level controls 0% (mimimum)
-48dB
Nominal System Noise, all level controls at 50%
+70dB
Mic to Speaker Output (CH 1 & CH2)
+56dB
Line to Speaker Output (CH1 & CH2)
+42dB
Aux In to Speaker Output
4kHz and above, 800Hz and below
Both jacks accept a balanced input and sends a pre-master volume output mix of
channels. Recommended use: Linking two Kustom models
Line Out
20 Hz-150Hz
Line Out
Balanced TRS Output with grounded sleeve
+15V
Mic inputs (CH1 & CH2)
USA/Canada
120VAC/60Hz, 160W nominal
Europe
230VAC/50Hz, 160W nominal
UK
230VAC/50Hz, 160W nominal
Australia
240VAC/50Hz, 160W nominal
Japan
100VAC/50-60Hz, 160W nominal
Two 6"
8 ohm each
1" Neodymium Compression Driver
80Hz-20kHz
Full range (subwoofer jack not used)
150Hz-20KHz
Crossover Active (1/4" mono plug in subwoofer jack)
4 ohm
Not designed for external speakers
Bluetooth 3.0+EDR compliant. Typical +2dBm Class 2 output
power. Audio DAC:94dB SNR. A2DP profile support
240mm D x 205mm W x 550mm H / 10.20 kg
mm/kg
9.5" D x 8" W x 21.65" H / 22.5 lbs
Inches/Pounds
Advertisement
