Planar BAT-24CM Operation Manual page 23

QUICK LINKS
Contents
Index
Regulatory Compliance
Product Information
Warranty
GETTING STARTED
About the Battery System
Locate Battery Housing
Identify Connector Ports
Install Battery Fuses
USING THE BATTERY
Charge Battery
Set Up Power Management
MAINTAINING THE BATTERY
Replace Battery
Troubleshooting
APPENDIXES
Battery Disposal
Specifications
Four modes of the battery system
Charging mode The battery system is plugged into an AC power source. During charging
mode, the attached load to the battery system is operational. The
batteries charge. The cooling fan runs only when the unit is plugged
into an AC power source.
Running mode The batteries have some level of charge and the battery system is not
plugged into an AC power source. During running mode, the attached
load to the battery system is operational. The batteries discharge. The
cooling fan is off. The load to the battery system is active.
Stand-by mode The batteries have some level of charge, the battery system is not
plugged into an AC power source, and the load is either disconnected
or off. The cooling fan is off. The load is powered when the system is
either turned on or reconnected.
Off mode The batteries have no charge and the battery system is not plugged
into an AC power source. During off mode, the attached load to the
battery system is not operational, whether connected or turned on.
The controller board is in sleep mode. The cooling fan is off. Plug the
battery system into an AC power source to leave off mode.
Invitium Battery System BAT-24CM
–MORE–
18