Table of Contents
Advertisement
Advanced Functions
DVD Functions
PLAY button is used to start Disc playback and for
Menu selection on some DVD players.
STOP button stops Disc playback.
PAUSE button pauses Disc playback - press PLAY to
resume.
INPUT activates the DVD Player's SETUP Menu.
INFO button brings up DVD Display or Control Menu
for Chapter/Track/Title number, Time remaining/elapsed
indication, system information, etc.
MENU brings up the DVD disc Menu screen - use with
the UP, DOWN, LEFT & RIGHT navigation buttons.
OK button is used for on-screen Menu selection. Note
some DVD players require the PLAY button to be used.
OK means same as SELECT - some manufacturers use
OK label and others use SELECT label on their remotes.
EXIT button is used to Exit or Clear on-screen Menu
displays.
TV/VCR/INPUT
When in TV mode the TV/VCR/INPUT button performs
the INPUT source switch function.
When in a mode that has been programmed for VCR the
TV/VCR/INPUT button performs the TV/VCR antenna
switch function.
When in a mode that has been programmed for Cable the
TV/VCR/INPUT button performs the A.B switch
function.
When in a mode that has been programmed for SAT the
TV/VCR/INPUT button performs the TV/SAT switch
function.
When in a mode that has been programmed for DVD the
TV/VCR/INPUT button performs the DVD Setup
function.
TV/VCR and TV/DVD Combo units
Note that for some TV/VCR and TV/DVD combo units
you might need to set up two different buttons to
control both parts of the combo unit. E.G., (referring to
the Direct Code Entry section on the following page)
you might need to set up a code under the TV button to
control the TV part of the combo unit AND a separate
code for the VCR or DVD under any other button you
choose.
8
Code Entry
Direct Code Entry
1. Press and quickly release the desired mode button
(
,
, etc.).
TV
VCR
2. Press and hold the
SETUP
buttons blink green, then the button you pressed in
step 1 stays on, then release the
3. Enter the 3 digit code from the code tables (on
separate sheet). Note: after a valid code entry, the
green indicator turns off. For an invalid code, the
green indicator flashes.
4. With your device on, press
device responds, no further programming is
required. Note: If some buttons do not operate your
equipment, try one of the other codes for your
brand.
1.
2.
3.
Write your codes down here for easy reference later.
Type
Type stored
VCR
DVD
TV
TV
Cable
SAT
9
button until the Mode
button.
SETUP
. If the
CHANNEL UP
Code
Advertisement
Table of Contents
