Advertisement
Configuration and installation processor guide
5. HOW TO CONFIGURE THE CROSSOVER:
Press the ESC button to go initial display.
Turn the Encoder until the Crossover function.
2º Step: freq HP
1º Step: Filters
CH1 =>HPF: 500 Hz
CROSSOVER
ATEN:12 dB/8
Press the channel to
Turn the Encoder:
configure:
Press the encoder to
choose the attenuation.
5º Step: Choose the attenuation
4º Step: freq LP
CH1 =>LPF: 20000 Hz
CH1
LPF: 2000 Hz
ATEN:12 dB/8
=> ATEN:12 dB/8
Turn the Encoder:
Turn the Encoder:
Choose the
Choose the frequency.
attenuation. Press
Press the Encoder to
choose attenuation.
ESC to go back at
previous function.
6. LIMITER Ch1, Ch2, Ch3, Ch4, Ch5, Ch6):
Press the ESC button to go initial display.
Turn the Encoder until the Limiter function:
1º Step: LIMITER
2º Step: TRESHOLD
LIMITER
CH1>T: 0 dB
A:45ms D:12 dB/s
Turn the Encoder:
Press the channel to
configure:
Choose the Threshold
value. Press the
Encoder to choose the
Attack.
7. GAIN (Ch1, Ch2, Ch3, Ch4, Ch5, CH6):
Press the ESC button to go initial display.
Turn the Encoder until the Gain function:
1º Step: Delay
2º Step: Distance
GAIN
CH1>GAIN: 06 dB
Choose and press the
Turn the Encoder:
CH button to configure.
Choose the gain. Press
ESC button to go back.
5
1
3º Step: Choose the attenuation
CH1
HPF: 500 Hz
=> ATEN:12 dB/8
Turn the Encoder:
Choose the
attenuation, Press the
Encoder to go to Low
Pass filter.
Repeat the steps 1, 2, 3,
4 and 5 to configure
others ones.
3º Step: Attack
4º Step: Decay (release)
CH1>A: 45 ms
CH1>D: 12 dB/s
D:12dB/s T:0 dB
T:0dB A:45ms
Turn the Encoder:
Turn the Encoder:
Choose the Attack
Choose the release.
value. Press the
Press the ESC button
Encoder to go Decay.
to go back previous
function.
RESET
The Reset button when pressed, for a certain
time, returns to factory configurations,
memories and parameters.
For use the Reset function, keep pressed the
Reset button until restart the PX-2.
ALWAYS DISCCONECT THE REMOTE
BEFORE USING THE RESET FUNCTION.
Configuration and installation processor guide
2
Advertisement
