Mounting Instructions - S-Tech STCP-1000 Owner's Manual

CAUTION!
WIRING THE DETECTOR.
STCP-1000HW and STCP-1000HWR should be installed on a U.L. listed or
recognized junction box.
Installation of STCP-1000HW:
STCP-1000HW has one set of AC power wire harness. For the AC Power Quick
Connector wiring connection, the black wire is connected to 120VAC Hot line, and
the white wire is connected to the Neutral line (see Figure 3A).
Installation of STCP-1000HWR:
STCP-1000HWR has two sets of wire harness, AC power and relay.
For the AC Power Quick Connector wiring connection, the black wire is connected
to 120VAC Hot line, and the white wire is connected to the Neutral line (see Figure
3A).
For the Relay Quick Connector wiring connection, see Figure 3B. Green wire is
Common (COM) contact, blue wire is Normally Open (NO) contact, and yellow wire
is Normally Closed (NC). Connect the blue wire (NO) to the supply side of the
device for switching it on when the detector sounds, instead of the yellow wire (NC)
for switching the device off.
b. MOUNTING INSTRUCTIONS
• Remove the mounting plate from the back of the detector (slide to the unlock
position to remove).
• After selecting the proper detector location as described in section 3, and wiring
the Quick Connect harness as described in the WIRING REQUIREMENTS,
attach the mounting plate to the electrical box (see Figure 4).
• Secure the mounting plate to the electrical box using the appropriate holes (see
Figure 4).
• Pull the Quick Connectors through the center hole in the mounting plate and
mount the same.
• Plug the mating halves of the Quick Connector together.
• Install the detector on the mounting plate and slide the detector to the lock
position.
• Turn on the A.C. power. The green A.C. "power on" indicator should be lit when
the detector is receiving A.C. power.
After installation, TEST your detector by pressing and holding the TEST/RESET
button for several seconds. See Testing in section 6.
TURN OFF THE MAIN POWER TO THE CIRCUIT BEFORE
- 5 -