S-Tech STCP-1000 Owner's Manual page 4

5. INSTALLATION INSTRUCTIONS:
NOTE!
REVIEW SECTION 3, RECOMMENDED LOCATIONS OF DETECTORS
AND SECTION 4, LOCATIONS TO AVOID, PRIOR TO INSTALLING YOUR
DETECTOR.
The proper power for the STCP-1000 series propane gas detectors is 120 volt single
phase, supplied from a non-switchable circuit which is not protected by a ground fault
interrupter.
a. WIRING REQUIREMENTS
Installation of STCP-1000:
The model STCP-1000 is a direct plug in unit. Be sure that the outlet on which you
install the detector is not controlled by a switch and the detector is not obstructed by
furniture, drapes etc.
Installation of STCP-1000LC:
Model STCP-1000LC is designed to be wall mounted. It has an attached 6-foot line
cord. Be sure that the outlet into which you plug the detector is not controlled by a
switch and the detector is not obstructed by drapes etc. Remove the mounting
plate from the back of the detector (slide to remove).
Using the enclosed screws and anchors install the mounting plate on the wall 2 to 3
feet above the floor within cord reach of the outlet.
Install the propane gas detector on the mounting plate and slide to the left to lock
the detector in place.
LIVE
(120VAC)
NEUTRAL
BLACK
(AC HOT)
AC Power
Quick
Connector
STCP-1000HW
FIGURE 3: Wire Harness
FUSE OR CIRCUIT BREAKER
BLACK
(AC HOT)
WHITE
(NEUTRAL)
AC Power
Quick
Connector
STCP-1000HWR
A) 120VAC Wire Harness
- 4 -
STCP-1000HWR
WHITE
RELAY CONTACTS
(NEUTRAL)
RATED 1A 24V AC/DC
B) Relay Wire Harness
Relay Quick Connector
BLUE (NO)
GREEN (COM)
YELLOW (NC)