Advertisement
Before installation select a suitable location for the fan where it is unlikely to
cause an obstruction.
Draw a vertical centre line approx. 40mm long on the wall
Draw a horizontal line to mark the centre line for the screw holes approx.
30mm long.
Now mark 2 holes 10mm either side of the centre line.
Drill holes on the marked points using a 6 mm (¼") masonry bit, and insert a
wall-plug.
Insert the screws and tighten to 2-3mm from the wall..
Slide the fan onto the screws and ensuring the fan is fully down on the
keyhole slots and the fan cannot pull away from the wall.
Plug the mains lead into a 13 Amp mains socket. If any other appliances are
connected to the same extension lead, make sure that it is rated for the total
power of all appliances connected.
If connecting via an extension lead, make sure that the lead is rated at 3
Amps or more, and that it is fully unwound.
Switch the appliance on at the mains socket.
The unit can be operated by the use of either the control buttons on the
panel or the supplied remote control.
Use the On/Speed button to start the fan, initially the fan will operate at low
speed. Press the On/Speed button to choose between Low/Medium and
High Speed
The swing button allows the unit to oscillate the fan head to cover a greater
area.
To switch Off push the OFF button.
Installation
OPERATION
3
Advertisement
