ABB REM 610 Installation Manual page 14

5(0 

14
0RWRU 3URWHFWLRQ 5HOD\
Installation Manual
:DOO PRXQWLQJ
Kit 1MRS050697 is used for mounting the case on a wall, i.e. projection mounting,
and contains two two-piece mounting brackets (frame and rail parts), a backplate
and screws. The mounting brackets are made of prepainted (light-grey, Pantone 420)
steel sheet. The kit also includes detailed mounting instructions and dimensions for
screw holes.
A wall-mounted case can be pulled out 160 mm and turned 45 (or 90) degrees
downwards (or upwards) when the wires are to be connected. Part "A" locks the case
to selected (pushed-in or pulled-out) position, see figures below. The case is released
by pushing the locks. By loosening the knurled-head screw "B", the case can be
rotated, see .
Fig. 4.6.-2
214 214 214 214 214
253 253 253 253 253
)LJ  5HOD\ FDVH DQG SOXJLQ XQLW ZDOO PRXQWHG
413
B
)LJ  :DOOPRXQWHG UHOD\ LQ SXOOHGRXW SRVLWLRQ DQG URWDWHG
177 177 177 177 177
A
Min 50 mm spacing
between two kits
50 mm space needed
above and below
the frame for rotating
A
1MRS 752265-MUM
450