Klipsch Reference Premiere RP-450C Service Manual page 17

Service Manual – Consumer
Once the screws have been removed, the tweeter will look as such.
Next, replace the tweeter back into position on the horn lens, and reattach the screws.
Plug the wires on to the new tweeter, and slide the silicone covers back over the terminals.
Place the tweeter back into position inside the cabinet and replace the six (6) screws.
Replace the horn lens by setting into position and gently pressing the trim ring around the
edge, verifying the clips on the back are locking into place. Once this is done, the trim ring
should sit flush with the front of the speaker
17