Pioneer PD-F1039 Operating Instructions Manual page 17

VARIOUS OPERATIONS
The following operations can only be performed
during stop mode
<Programming an entire disc as one step>
(Disc all program)
3
If you skip step of the operation example, disc 2 is programmed
as step 1 .
<Programming a pause (remote control only)>
(Pause program)
If you press 8 at step
4
, you can program a pause. When you
press 8, "PA" appears in the display instead of the disc number.
• For example, when making a program for recording both sides
of a cassette tape, press 8 to insert a pause after programming
the tracks for one side. After turning the tape over, press 8 to
resume recording.
Notes!!
• You cannot program a pause as the first step, nor program
two pauses in a row.
• When you program a pause, it counts as 1 step and
reduces the total number of tracks you can program.
• To erase a program...
Press 7 twice during playback (or once in stop mode). You can
also erase the program by pressing MODE, RANDOM,
PREVIOUS, or SINGLE LOADER PLAY in either play or stop
mode (or by pressing BEST in stop mode).
• To cancel a program step
In stop mode, each time you press CLEAR, the last step in the
program is erased.
• If a programmed disc is missing or inserted backwards during
program play, "NO DISC" appears in the display, the step is
automatically erased, and playback proceeds to the next step.
• Program contents are stored in memory even when the
power is turned off.
• Press the TIME/CHARA twice to check the number of steps
that have been programmed.
RENTAL DISC TRACK REMAIN MIN SEC
ALL RANDOM REPEAT - 1 BEST ADLC CUSTOM
SINGLE CD TEXT PREVIOUS SCAN PROGRAM
(Memory Back-Up Function)
Memorized data will be stored in memory for approx. 1 month
even if the power cord is unplugged. However, this period may be
shortened somewhat, depending on the amount of memory used.
This indicates the number
of programmed steps.
Notes!!
5
• If step is carried out before the accumulated time is
displayed, the program play starts and the time is not displayed.
• When UNLOAD is pressed while a program has been entered,
the disc for the 1st program step comes on the center position
and the hood opens.
• The display is not shown if the total time of the program is 100
minutes or more.
• When another PD-F1039 is connected to create a 602-disc
changer, only the discs loaded in one of the PD-F1039's can be
programmed. It is not possible to program discs from both of
the PD-F1039s.
• The following restrictions apply to programming when 2 PD-
F1039 units are connected.
• When inputting program data with the remote control unit,
when the 1st disc number is P0 or between 1 and 300,
program input will be on the MASTER unit. When between
301-600, program input will be on the SLAVE unit.
• Carry out programming of the SLAVE unit's P0 using the
controls on the SLAVE unit.
• When programs are input on both the MASTER unit and
SLAVE unit, program playback will start from the unit that
PLAY is pressed on. After playback has finished, pressing
PLAY on the other unit will start playback on that unit.
(RELAY PROGRAM play is not possible.)
When PLAY is pressed on the remote control unit, the
program on the MASTER unit will playback.
17