Compliance Information - Recon Snow2 User Manual

Compliance Information

FCC Compliance Class B Digital Device
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
FCC Declaration of Conformity
Snow2 (FCC ID: ZW5008) and Recon-Ready Remote (ZW5001) comply
with FCC standard CRF 47 Part 15 subpart B and subpart C – section
15.249. Operation is subject to the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including
interference that may cause undesired operation.
European Conformity Compliance
This product complies with the Low Voltage
Directive 2006/95/EC; EMC Directive 2004/108/EC,
EU Directive R&TTE Directive 1999/5/EC, and RoHS Directive
2011/65/EU. Point of contact: Intel Corporation, Atn: Corporate
Quality, 2200 Mission College Blvd., Santa Clara, CA 95054 USA
ProductEcology@intel.com.
24 | P a g e
Industry Canada Compliance
Snow2 and Recon-Ready Remote were certified with IC numbers
9717A-008 and 9717A-001, respectively. These digital apparatus do
not exceed the Class B limits for radio noise emissions from digital
apparatus set out in the interference causing equipment standard
entitled: "Digital Apparatus," ICES-003 of the Canadian Department of
Communications.
Snow2 et Recon-Ready Remote ont été certifiés avec les numéros IC
9717A-008 et 9717A-001, respectivement. Ces appareils numériques
respectent les limites bruits radioélectriques applicables aux appareils
numériques de Classe B prescrites dans la norme sur le matériel
brouilleur: "Appareils Numériques", NMB-003 édictee par le Ministre
Canadian des Communications.
These devices comply with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1)
these devices may not cause interference, and (2) these devices must
accept any interference, including interference that may cause
undesired operation of the device.
Les présents appareils sont conformes aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) les appareils ne doivent
pas produire de brouillage, et (2) l'utilisateur des appareils doit
accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
Industry Canada ICES-003 Compliance Label: CAN ICES-3 (B)/NMB-
3(B)
Japanese Radio Law and Japanese Business Law
Compliance
Snow2 (R: 202-SMB048, T: D 13-0023 202) is granted
pursuant to the Japanese Radio Law (ordinance of
MPT No. 37,1981) and the Japanese Business Law (Article 56,
Paragraph 1).
Australia and New Zealand Radiocommunications
Compliance
The RCM indicates a device's compliance with
applicable ACMA (Australian Communications and Media Authority)
technical standards –
radiocommunications, EMC and EME – and with applicable state and
territory electrical equipment safety requirements.
that is, for telecommunications,