Troubleshooting; Gps; Agps (Assisted Gps) For Your Snow2; Factory Reset - Recon Snow2 User Manual

Troubleshooting

GPS

GPS technology works best in open spaces with a clear view of the sky. Obstructions such as buildings and trees can
degrade the GPS signal. Your Snow2 will automatically acquire a GPS fix each time you use your snow2.
If you are having difficulty acquiring a GPS fix on your Snow2, this may be due to one of the following factors:

You are using the device indoors.

Your device is trying to acquire a GPS fix for the first time.

Your device has not been used for an extended period of time.

AGPS (Assisted GPS) for your Snow2

AGPS helps to locate satellites within your local area, helping speed up the process of getting a GPS fix for your Snow2.
To activate AGPS, connect your Snow2 to your computer, run Recon Uplink, and log in if needed. Recon Uplink will then
automatically sync your Snow2 to your Recon Engage account and transfer AGPS files to your HUD for your current
location.
If you still experience difficulty when trying to acquire a GPS fix, try powering down your Snow2 and restarting it
outdoors (away from any obstructions, if possible).

FACTORY RESET

A factory reset clears all data that your Snow2 has recorded. It also un-pairs the remote, clears your settings, uninstalls
any third-party apps, and restores the device back to the default settings and original firmware the Snow2 was shipped
with.

To perform a factory reset, go to Settings > Advanced > Factory Reset

REMOTE PAIRING

Your remote automatically comes paired with your Snow2. However, if you perform a factory reset or happen to lose
your remote/purchase a new one, you will be required to re-pair the remote to your Snow2 again.
To un-pair remote, simultaneously press and hold the Left and Right buttons on the remote until you see the LED
Indicator on your remote flash amber. Your Snow2 status bar will have the remote is not paired and not connected to
Snow2 icon.

Pairing your Remote to your Snow2

Note the ID number on the back of the remote printed on white label.
1. Power off your Snow2 and power it on again.
2. Press any button on the remote and wait for prompt on your Snow2 to select the remotes ID number.
18 | P a g e