Sony HT-CT800 Operating Instructions Manual page 57

[On]: The system reproduces the dolby
sound track with the kind of dynamic
range that the recording engineer
intended.
[Off]: No compression of dynamic
range.
[Audio Output]
You can select the output method used
for audio signal output.
[Speaker]: Outputs multi-channel sound
from the system's speakers only.
[Speaker + HDMI]: Outputs multi-
channel sound from the system's
speakers and 2-channel linear PCM
signals from the HDMI OUT (ARC) jack.
Note
When [Control for HDMI] is set to [On]
(page 58), [Audio Output] is set to
[Speaker + HDMI] automatically and this
setting cannot be changed.
[Sound Effect]
You can turn on/off the sound effect
such as the sound field.
[Sound Field On]: Enables all sound
effects.
[DTS Neo:6 Cinema]/[DTS Neo:6 Music]:
Performs DTS Neo:6 Cinema/Music
mode decoding. For 2 channel source,
the system simulates surround sound
from 2 channel sources and produces
multi-channel sound. For multi-channel
source, the system outputs sound from
the speakers depending on the number
of channels of the source.
Note
This item can be selected only when
using the wireless surround function.
[Bluetooth Settings]
[Bluetooth Mode]
You can enjoy content from a
BLUETOOTH device by using this system
or listen to sound from this system by
using BLUETOOTH-compatible
headphones.
[Receiver]: This system is in receiver
mode, which enables it to receive and
output audio from the BLUETOOTH
device.
[Transmitter]: This system is in
transmitter mode, which enables it to
send audio to the BLUETOOTH-
compatible headphones. If you switch
the input of the system, "BT TX" appears
on the front panel display.
[Off]: The BLUETOOTH function is turned
off and you cannot select the [Bluetooth
Audio] input.
Note
You can connect to a
device* by using the One-touch function
even if you have set [Bluetooth Mode] to
[Off].
* Only mobile devices such as a
smartphone, tablet, WALKMAN®
[Device List]
Displays a list of paired and detected
BLUETOOTH devices (SNK device) when
[Bluetooth Mode] is set to [Transmitter].
[Bluetooth Standby]
You can set the [Bluetooth Standby] so
that the system can be turned on by a
BLUETOOTH device even when the
system is in standby mode. This
function is only available when you set
[Bluetooth Mode] to [Receiver] or
[Transmitter].
[On]: The system turns on automatically
when you request a BLUETOOTH
connection from a paired BLUETOOTH
device.
[Off]: Off
[Bluetooth Codec - AAC]
This function is only available when you
set [Bluetooth Mode] to [Receiver] or
[Transmitter].
[On]: Enable AAC codec.
[Off]: Disable AAC codec.
BLUETOOTH
57
US