How To Connect The Lcd Program Card - Hobby King X-Car 120A User Manual

120A/150A ESC

How to connect the LCD program card:

1. Disconnect the battery from the ESC;
2. Disconnect the signal cable of the ESC from the receiver; then plug it into the socket marked
with ( )
3. Connect the battery to the ESC and turn on the ESC.
4. X-Car Gecko /Version/Date will be displayed on the LCD screen when ESC is connected,
then press any buttons "Ready to connect ESC" will be showed on the LCD Screen., this means
that connection between LCD and ESC is established.
If the data connection between LCD and ESC is failed, the LCD Screen is always showing
(Ready to connect ESC); Please check if signal wire is connected correctly; if not repeat step1-
5. If the connection is established successfully, the first programmable item will be displayed
on LCD screen. It's ready to set the parameters now.
Note1: Please strictly connect according to the above sequence. The sequence of step 2 and step
3 can not be reversed. Otherwise, the LCD program card can not work properly.
Note2: A separate power is needed if the ESC is without BEC.
Connect an additional power (5-12V) to the socket marked with ( ) on the left of the LCD
program card for power supply. Please be sure that the polarity is connected correctly.
13