Resetting The Main Unit; Switching The Speaker Impedance - Pioneer VSX-415 Operating Instructions Manual

Additional information
Problem
When a search is performed
by a DTS compatible CD
player during playback, noise
is output.
Can't operate the remote
control.
The display is dark or off.

Resetting the main unit

Use this procedure to reset all the receiver's
settings to the factory default. Use the front
panel controls to do this.
VSX-415 model:
1 Switch the receiver into standby.
2 While holding down the TONE button,
press and hold the STANDBY/ON button for
about three seconds.
3 When you see RESET? appear in the
display, press the TONE button.
OK? shows in the display.
4 Press TONE once more to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.
VSX-515 model:
1 Switch the receiver into standby.
2 While holding down the TONE button,
press and hold the STANDBY/ON button for
about three seconds.
3 When you see RESET? appear in the
display, press the ENTER button.
OK? shows in the display.
Remedy
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
• Replace the batteries (refer to page 5).
• Operate within 23 ft. (7 m), 30° of the remote sensor on the front
panel (refer to page 5).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Press FL DIMMER on the remote control repeatedly to return to
the default.
4
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.
Switching the speaker
impedance
We recommend using speakers of 8Ω with this
system, but it is possible to switch the imped-
ance setting if you plan to use speakers with a
6Ω impedance rating.
•
STANDBY/ON while holding down the
SPEAKER IMPEDANCE button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your
• SP 8 OHM – Use this setting if your
Press SYSTEM SETUP to confirm.
With the receiver in standby, press
speakers are rated at 6Ω.
speakers are rated at 8Ω or more.
10
51
En