Setting Up Using Full Library Search - Pioneer Elite VSX-41 Operating Instructions Manual

09 Controlling the rest of your system
Setting Up Using Full Library
Search
An alternative method of setting up the remote
with preset codes is to use the Library Search
feature. The remote transmits batches of 10
codes; when you see the component you want
to control respond (by turning on or off) you
just scan through those last 10 codes until you
find the correct one.
1 Switch on the component you want to
control.
If the component is some kind of player (CD
player, VCR, etc.), then start it playing.
2 Press and hold REMOTE SETUP for
three seconds.
The LCD display shows SETUP.
48
En
SOURCE RECEIVER
LEARN ERASE SEARCH BY BRAND
DVD TV VCR CD-R
MULTI CONTROL
TUN
RCV CD TVC
2 3
1
TEST TONE INPUT ATT FL DIMMER
4 5 6
CH SELECT LEVEL
8 9
7
+10 EFFECT DISPLAY
DISC
0
ENTER
DTV INFO MPX/RETURN D.ACCESS T.EDIT/GUIDE
3
¶
7 8
BAND CLASS DTV ON/OFF DTV MENU
1 ¡
4 ¢
TOP MENU AUDIO SUB TITLE ANGLE
REMOTE SETUP STANDARD ADV.SURR. STEREO
MIDNIGHT/
INPUT SEL. MUTE
SIGNAL SEL LOUDNESS
RECEIVER CONTROL
TUNE
T
ST ST
ENTER
TUNE
CHANNEL
MENU
MASTER VOLUME
TV VOL TV INPUT
TV
TV CONTROL
3 Press the MULTI CONTROL button for
the component you want to control.
4 Use the } and ] buttons to select the
SEARCH.
The LCD display shows SEARCH.
5 Press and hold REMOTE SETUP for
three seconds.
A batch of 10 codes is transmitted and the
transmit icon blinks during transmission.
If you see the component respond, by
stopping (for playback components only) or
switching off, go on to the step 6, otherwise
press and hold the REMOTE SETUP button
for three seconds.
Cancelling this step can only be done after
the 10 codes are transmitted.
6 Switch the component back on or
restart playback.
7 Use ' and ' buttons to scan step-by-
step through the last 10 codes
transmitted to identify the correct code.
Stop when you see the component stop or
switch off. The LCD display shows the I.D.
You can also verify you have the correct
code by pressing PLAY, STOP., VOL +/–, etc.
8 Press and hold ENTER for three
seconds to save the preset code.
The LCD display shows OK.
The remote control automatically returns to
normal usage.
• Unless otherwise stated, you can cancel or
exit any of the steps by pressing and holding
MUTE for three seconds.
• The remote control will return to its previous
mode after 30 seconds of inactivity.