Programming Signals From Other Remote Controls; Erasing One Of The Remote Control Button Settings - Pioneer VSX-1125-K Operating Instructions Manual

Controlling the rest of your system
Programming signals from other
remote controls
If the preset code for your component is not available, or
the available preset codes do not operate correctly, you
can program signals from the remote control of another
component. This can also be used to program additional
operations (buttons not covered in the presets) after
1
assigning a preset code.
Certain buttons represent operations that cannot be
learned from other remote controls. The buttons
available are shown below:
RECEIVER MULTI SOURCE
OPERATION
R.SETUP
BD DVD DVR/BDR HDMI
TV CD NET RADIO ADAPTER
iPod USB TUNER SIRIUS XM
RECEIVER
INPUT SELECT TV CTRL
MASTER
INPUT VOLUME
TV CONTROL
CH VOL
MUTE
1 Press and hold R.SETUP, then press "2" for three
seconds.
The LED flashes continuously.
• To cancel the preset setup mode press R.SETUP.
2 Press the input function button for the component
you want to control.
The LED blinks once and flashes continuously.
3 Point the two remote controls towards each other,
then press the button that will be doing the learning on
this receiver's remote control.
The LED blinks once and flashes continuously.
Note
1 The remote can store about 120 preset codes from other components (this has been tested with codes of Pioneer format only).
2 • Note that interference from TVs or other devices will sometimes result in the remote control learning the wrong signal.
• Some commands from other remote controls cannot be learned, but in most cases the remotes just need to be moved closer together or
farther apart.
• If the LED flashes for five seconds, it means the memory is full. See Erasing all learnt settings that are in one input function on page 68 to
erase a programmed button you're not using to free up more memory (note that some signals may take more memory than others).
AUDIO VIDEO
PARAMETER PARAMETER
LIST TUNE TOOLS
TOP MENU T.EDIT
BAND GUIDE
PRESET ENTER PRESET
CATEGORY RETURN
HOME
TUNE
MENU
iPod CTRL
AUTO / ALC / PGM MEMORY MENU
DIRECT STEREO STANDARD ADV SURR
HDD DVD
THX PHASE CTRL STATUS
TV / DTV MPX PQLS
HDMI OUT AUDIO
1 2 3
SIGNAL SEL MCACC SLEEP INFO
4 5 6
DISP
CH LEVEL A.ATT DIMMER
7 8 9
CH
D.ACCESS CLASS
/ CLR 0 ENTER
ZONE 2 ZONE 3 LIGHT
• The remote controls should be 3 cm (1 inch) apart.
(1 inch)
This receiver's
remote control
4 Press the corresponding button on the other remote
control that is sending (teaching) the signal to this
receiver's remote control.
If the LED lights for one second, the setting has been
2
successfully completed.
5 To program additional signals for the current
component repeat steps 3 and 4.
To program signals for another component, exit and
repeat steps 2 through 4.
6 Press R.SETUP to exit the programming mode.
Erasing one of the remote control
button settings
This erases one of the buttons you have programmed and
restores the button to the factory default.
1 Press and hold R.SETUP, then press "7" for three
seconds.
The LED flashes continuously.
• To cancel the preset setup mode press R.SETUP.
2 Press the input function button corresponding to
the command to be erased, then press ENTER.
The LED flashes once.
3 Press and hold the button to be erased for three
seconds.
If the LED lights for one second, the erasing has been
successfully completed.
4 Repeat step 3 to erase other buttons.
5 Press R.SETUP to exit the erasing mode.
3 cm
Other remote
control
09
67
En