Using Nonfading Output; Using The High Pass Filter - Pioneer AVH-P4900D Operation Manual

Operating this unit
2 Touch c to turn subwoofer output on.
# To turn subwoofer output off, touch d.
3 Touch b and then touch c or d to se-
lect the phase of subwoofer output.
Touch d to select normal phase and
NORMAL appears in the display. Touch c to
select reverse phase and REVERSE appears in
the display.
4 Touch b and then touch c or d to ad-
just the output level of the subwoofer.
Each time you touch c or d increases or de-
creases the level of the subwoofer. +6 to –6 is
displayed as the level is increased or de-
creased.
5 Touch b and then touch c or d to se-
lect cut-off frequency.
Each time you touch c or d selects cut-off fre-
quencies in the following order:
50Hz—80Hz—125Hz
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
Boosting the subwoofer level
You can easily boost the subwoofer bass level
by repeatedly pressing BOOST button. If the
subwoofer is set to OFF, pressing BOOST but-
ton automatically sets the subwoofer to ON.
% Press BOOST button to increase the
subwoofer level.
The subwoofer level 0 to +6 is shown in the
display.
# To decrease the level, press BOOST button
and hold. The subwoofer level is reset to 0 and
then you can start again.
Note
You can also select the subwoofer level in the
audio menu. Refer to Using subwoofer output on
the previous page.

Using nonfading output

When the nonfading output setting is on, the
audio signal does not pass through this unit's
low pass filter (for the subwoofer), but is out-
putted through the RCA output.
1 Touch NON FADING on the audio func-
tion menu.
# When the subwoofer controller setting is only
FULL, you can select NON FADING. (Refer to
page 39.)
2 Touch a to turn non fading output on.
# To turn non fading output off, touch b.
3 Touch c or d to adjust the output level
of the non fading.
Each time you touch c or d increases or de-
creases the level of the non fading. +6 to –6 is
displayed as the level is increased or de-
creased.

Using the high pass filter

When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn on the
HPF (high pass filter). Only frequencies higher
than those in the selected range are outputted
from the front or rear speakers.
1 Touch NEXT on the audio function
menu.
2 Touch HPF.
Section
03
33
En