Advertisement
OPERATION
6
IMPORTANT: Always use an RCD (Residual Current Device) adaptor when using this pressure washer.
WARNING: Don't leave the pressure washer running when not in use, or more than 5 minutes to prevent overheating.
Before switching the machine on, the trigger handle must be squeezed to release water and to remove any airlocks in
the machine or pressure hose. Always release any build up pressure in the handle prior to disconnecting the hose.
Make sure water supply
Connect water hose pipe
is not connected. Firmly
to a suitable water supply
push the water hose
and turn water on.
pipe with suitable
connector onto the water
inlet to lock into position.
Push the 'I' switch to
Squeeze the trigger on
turn on. The machine
the trigger handle to
will run for a few
release a high pressured
seconds then stop
water jet, and start
but no water will be
cleaning.
released.
WARNING:
Don't aim the pressure washer di-
rectly at people, animals, plants,
electrical components, wires or
the pressure washer itself.
Push 'O' switch to
turn off.
Connect the power
Before plugging the
cord to the mains
machine in, press the
supply via an
unlock safety button on
RCD adaptor.
the trigger handle and
squeeze the trigger
until water starts to flow
through the nozzle.
IMPORTANT: Always make sure the machine is switched off and the safety button on the trigger handle is
LOCKED before connecting/disconnecting the lance, nozzle or accessories.
Using your accessories
The jet nozzle has a wider spray and is ideal for use on surfaces areas such
as cars, garden furniture, decking and boats.
To attach the jet/solution
Hold down the release button on the
nozzle. Fit the lance
lance, push the jet nozzle and lance
with a firm push and twist
firmly together until you hear an audible
clockwise to lock into
CLICK. Release the button and gently pull
place.
the jet nozzle to make sure it is locked
securely before use.
The turbo nozzle has a more concentrated spray and is ideal for use on very dirty surfaces, patios or masonry.
As it is not fitted with a pressure regulator it is not suitable for use on delicate or painted surfaces.
To attach the turbo
Hold down the release button on the lance,
nozzle, fit the lance with
push the turbo nozzle and lance firmly together
a firm push and twist
until you hear an audible CLICK. Release
clockwise to lock into
the button and gently pull the turbo nozzle to
place.
make sure it is locked secure before use.
Squeeze the trigger on the trigger
handle to release a high pressured
water jet, and start cleaning.
OPERATION
Squeeze the trigger on the
trigger handle to release a
high pressured water jet,
and start cleaning.
WARNING:
Never use the turbo nozzle on
cars, tyres and engines.
7
Advertisement
