Chapter 2 Basic Setup; System Requirements; Installation - Sercomm xCAM User Manual

Chapter 2
Basic Setup
This Chapter provides information on how to install and configure the xCAM.

System Requirements

•
To use the Wireless interface on the wireless model, other Wireless devices must be
compliant with the IEEE802.11n, IEEE802.11b or IEEE802.11g specifications. All
Wireless stations must use compatible settings.
Mode: Infrastructure
SSID: ANY
Wireless Security: Disabled
Domain: USA
Channel No.: Auto

Installation

You must complete the following installation procedure when using the xCAM for the first
time.
Step 1 - Adding an xCAM to your network
Make sure the Router and the Touch Panel are both powered on and synchronized before
adding your xCAM. This step is required when an xCAM is used for the FIRST time. It only
needs to be done ONCE in order to configure the wireless settings for the xCAM.
Note: Skip this section if the xCAM has been set up already.
1.
On the Touch Panel, click on Setting icon on the home page.
Enter the "Master" code.
2.
3. Enter the "Technical code/ID", then click the "Done" button.
4. Select "Home Devices". Then choose "Cameras-> Add a Camera".
5. Click the "Next" button to check network.
2
6