Pioneer SX-SW570 Operating Instructions Manual page 12

02 Connecting up
2 Assemble the AM loop antenna.
a
a. Bend the stand in the direction indicated by the
arrow.
b. Clip the loop onto the stand.
c. If you want to fix to a wall or other surface, perform
step b after first securing the stand with screws.
It is recommended that you determine the reception
strength before securing the stand with the screws.
3 Connect the AM and FM antennas
a. Connect one wire of the AM loop antenna to each AM
antenna terminal
For each terminal, press down on the tab to open;
insert the wire, then release to secure.
b. Push the FM antenna
FM antenna socket.
4 Connect each speaker.
• The front and surround speaker cables have a color-
coded connector at one end and two bare wires at the
other end.
• Since there is only one terminal to connect the two
center speakers, you will need to use the supplied Y-
cable for the connection.
Note
1 • Keep antenna cables away from other cables, the display unit and receiver subwoofer.
• If reception with the supplied antenna is poor, see Improving poor FM reception and Improving poor AM sound on page 23 or Connecting
external antennas on page 27.
• Do not attach any antenna other than the provided loop antenna, or an external antenna as described on page 27.
2 • Don't let it come into contact with metal objects and avoid placing near computers, television sets or other electrical appliances.
• If radio reception is poor, you may be able improve it by re-inserting each antenna wire into the opposite terminal.
• For best reception, do not untwist the AM loop antenna wires or wrap them around the loop antenna.
12
3 To ensure optimum reception, make sure the FM antenna is fully extended and not coiled or hanging at the rear of the unit.
En
b c
1
.
2
.
1
2
3
plug onto the center pin of the
Color-coded wire
(Connect to speaker)
Color-coded connector
(Connect to rear panel)
• Twist and pull off the protective shields on each wire.
• Connect the wires to the speaker. Each speaker in the
illustration can be identified by means of the color-
coded indicator provided on the rear-surface model
label. Match the color-coded wire with the color
indicator on the model label, then insert the color-
coded wire into the red (+) side and the other wire
into the black (–) side.
• When connecting the center speakers, connect the Y-
cable dual end to the two center speakers in the
same way.
To Receiver subwoofer
• Connect the other end to the color-coded speaker
terminals on the rear of the receiver subwoofer. Make
sure to insert completely.
The small lug at the wire-end of the speaker plug
should face up or down depending on whether it's
being plugged into one of the upper or lower speaker
terminals. Please make sure to connect correctly.
Upper terminal
Y-cable
Lower terminal