JVC TH-C90A Service Manual page 29

3.3.2 Removing the rear panel
(See Figs.4 and 5)
• Prior to performing the following procedure, remove the ampli-
fier assembly.
(1) From the back side of the amplifier assembly, remove the
six screws C and screw D attaching the rear panel. (See
Fig.4.)
(2) Take out the rear panel with fan motor backward from the
amplifier assembly.
(3) From the top side of the amplifier assembly, disconnect the
fan wire from the connector
(See Fig.5.)
(4) Take out the rear panel.
3.3.3 Removing the fan motor
(See Fig.6)
• Prior to performing the following procedures, remove the am-
plifier assembly and rear panel.
(1) From the front side of the rear panel, remove the four
screws E attaching the fan motor.
(2) Take out the fan motor.
CN308 on the main board.
Rear panel C D C
Fig.4
CN308
Fan motor Fan wire
Fig.5
Rear panel
Fig.6
Main board
Rear panel
(No.MB570)1-29