Receiving A Status/Short Data Message Call; Call Displays; Viewing The Stack - Kenwood TK-785 Instruction Manual

Receiving a Status/Short Data Message Call

1 When a call is received, the
flashes.
• The indicator remains on the display when there is data in the stack.
2 To view the status or message, refer to "Viewing the Stack", below.

Call Displays

The following messages may appear on the display under certain circumstances:
Holding: The transceiver is confirming the call made by the base station.
Engaged: The called party is in another call.
Queued: All communication channels are currently in use; your status will be
sent when a channel becomes free.
Fail: The control station received an invallid call.
NU: You entered an invallid call address.
No Reply: The called party has been called, but they did not respond to the call.
Call Back: The called party has set their transceiver to queue all incoming calls.
Sys Busy: The system is currently busy.

Viewing the Stack

1 Press the Status/ Stack key (default is the A key) twice to enter the stack.
• If there is no data in the stack, "------------" appears on the main display and "-00"
appears on the 3-digit sub-display.
2 Press the
• "NEW" represents a new entry, "S" represents a status stack entry, "V" represents a
voice stack entry, and "D" represents a data stack entry.
3 Press the C and D
entire entry.
4 To erase an entry, select the desired entry and press the
10
/ (control) keys to view the stack entries.
keys to scroll through the selected entry, to view the
indicator appears on the display and
key.