Linde G-TECTA 4G Operating Manual page 16

16
G-TECTA 4G – PC Interface
®
and PC Software*
G-TECTA PC Software gives the user access
®
to data and event log files, printing reports,
reconfiguring alarm levels, instrument operation
functions, and running calibrations.
G-TECTA 4G can be connected to a PC by using
®
the G-TECTA 4G single drop in charger cradle with
®
optional PC interface. The charger cradle is fitted
with a D-type 9 pin RS232 socket. The PC requires
G-TECTA PC software and is connected to the
®
charger via a RS232 cable.
Note: A USB-RS232 adaptor is required for most
PCs or Laptops.
Set-up
1. Install G-TECTA PC software on the PC.
®
2. Where applicable, install USB software**
(supplied in USB adaptor box).
3. Attach the RS232 cable to the charger and
the RS232 cable with the USB adaptor
(where applicable) to the PC.
4. When using a USB adaptor to connect the
instrument, follow the procedure below:
(i) Before connecting the instrument, check the
available communications ports available on
the G-TECTA PC software options screen and
®
note the ports available
(ii) Switch on the G-TECTA
it into the charger cradle
(iii) Check the available communications ports
available again and select the new port or port
* G-TECTA PC Software can be downloaded free of charge from www.g‑tecta.com
®
** If the USB adaptor software does not start automatically, select UC232A, the appropriate operating system and install the driver
4G instrument and drop
®
4, 5 or 6 and save your changesby clicking
the save button on the bottom right of the
options screen
(iv) Close the G-TECTA
Note: If the instrument does not connect to
the PC, select a different communications port
and try again.
5. Switch on the G-TECTA
it into the charger cradle ensuring it is upright
and the display is facing forward.
6. Open the G-TECTA
either the Wizard or the Engineer's Form,
select G-TECTA 4G and upload the data from
®
the instrument.
7. The software will allow you to access data or
configure the instrument as required.
Note: For more information on using the G-TECTA
PC software, see the installed help file.
PC software.
®
4G instrument and drop
®
PC software and using
®
®