Removing The Pickup Unit - JVC KD-S6250 Service Manual

KD-S6250/KD-S580
Removing the feed motor ass'y
Prior to performing the following procedure, remove
the CD mechanism control board, the front bracket
(loading motor) and the CD mechanism ass'y.
1. Remove the two screws K and the feed motor ass'y.

Removing the pickup unit

*Prior to performing the following procedure, remove
the CD mechanism control board, the front bracket
(loading motor), the CD mechanism ass'y and the
feed motor ass'y.
1. Detach the FD gear part of the pickup unit upward.
Then remove the pickup unit while pulling out the
part n of the FD screw.
ATTENTION: When reattaching the pickuap unit,
reattach the part o of the pickup unit,
then the part n of the FD screw.
2. Remove the screw L attaching the nut push spring
plate and the pickup mount nut from the pickup unit.
Pull out the FD screw.
Removing the spindle motor
Prior to performing the following procedure, remove
the CD mechanism control board, the front bracket
(loading motor), the CD mechanism ass'y and the
feed motor ass'y.
1. Turn up the CD mechanism ass'y and remove the
two springs p on both sides of the clamper arms.
Open the clamper arm upward.
2. Turn the turn table, and remove the two screws M
and the spindle motor.
1-10
(See Fig.10)
(See Fig.10 and 11)
(See Fig.12 and 13)
FD screw
Feed motor ass'y
K
FD gear Pickup unit
Fig.10
Nut push spring plate
FD screw
Fig.11
p
Fig.12
Spindle motor
M
Fig.13
Part n
Part O
Pickup unit
L
Pickup mount nut
Pickup unit
p
M