Securing the Display
1. Tilt the flat panel and secure the two (2) M6 x 12 mm safety knobs to each of the mounting
brackets (Figure 17).
NOTE:
To remove the display from the wall simply extend the display to its maximum tilt range,
remove the two (2) M6 x 12mm Safety Knobs, push the flat panel back to it's flat position and
loosen or remove the two (2) M6 x 30 lateral shift screws and lift the unit of the wall.
Page 10
M6 x 12mm
Safety Knob
Figure 17
M6 x 12mm
Safety Knob
PWM-T210
Installation Instructions