Table of Contents
Advertisement
Securing the Lower Wall Plate
Level
Figure 11
1.
Level and secure the plate to the wall
with the reference arrow facing up to the
ceiling (Figure 11).
2.
Secure the plate using the provided lag
bolts and washers.
Securing the Upper Wall Plate
Figure 13
1.
Drill four (4) ¼" pilot holes in the
marked wall (Figure 13). These pilot holes
will be for the upper mounting bracket.
Page 8
Wall
Plate
3.
4.
5.
Wall
Marks
Wall
Plates
2.
3.
CAUTION: Do
NOTE: CHECK THE MOUNT FOR PROPER
Wall Plate
Figure 12
When the bottom wall plate is properly
installed to the wall.
Lay the carton template on top of the wall
plate.
Lay the top wall plate on top of the
cardboard template and mark the four (4)
mounting points (Figure 12).
Power Source
Area
Wall Plates
Figure 14
Level and secure the plate to the wall with
the reference arrow facing up to the ceiling.
Secure the plate using the provided lag
bolts (Figure 14).
not
mounting hardware.
TIGHTNESS AND SECURITY.
PWM-T210
Marked Wall
Template
over
tighten
the
Installation Instructions
Advertisement
Table of Contents
