Table of Contents
Advertisement
Attaching the Plasma Display
lilustration: when using support columns L
apes
—
The weight of a 50 inch plasma display is about 40 kg
A
(88 Ibs), that of a 43 inch model is about 30 kg (66 Ibs),
they have no depth, and are unstable. Therefore, at
least two people must assemble and install them.
Caution
@ Be sure to install it on a flat stable location.
@ Insert the screws in the holes vertically and do not tighten
them with more force than necessary.
@ Make sure that you instali the support columns reliably
according to the type of plasma display you have pur-
chased and the speaker settings with reference to the
procedure in, Assembling the Stand.
1 Attaching the plasma display to the stand.
Fit the stand's support columns into the siots in the center of
3 Securing the plasma display with attach-
the bottom of the plasma display then slowly insert them
ment screws 3.
directly into the siots. Be extremely careful not to insert the
Secure them using the enclosed hexagonal wrench.
support columns of the stand into any part of the plasma
display other than the stand insertion slots. Note that
doing
so might damage the plasma display panel or its ports or
result in the warping of the stand.
Line up the column
supports with the bottom
of the plasma display as
indicated in the accompa-
nying diagram.
* Attachment
screw
?
Only when attaching speakers at the bottom
of the plasma display
4 Inserting the spacers.
Insert the spacers in the hales on the rotating platform
ment screws
?.
Secure then usiig ihe eiciosed texayurial wretch.
_ Attachment screw °
5 Attaching the speakers.
Refer to the operating instructions for the speaker for
the installation method.
15
En
Advertisement
Table of Contents
