Step2: Connect The Speakers - Pioneer SC-LX502 Basic Manual

> Before Start > Part Names

Step2: Connect the Speakers

a
a Speaker Cable, b Subwoofer Cable
> Install > Initial Setup
3/8˝
(10 mm)
b
OR
Speaker B
> Playback
Standard Connections (Pages 8 to 12)
Connect 12345678 for a 7.1 channel system.
Connect 1234569: for a 5.1.2 channel system. Up
to two powered subwoofers can be connected. The same
signal is output from each of the SUBWOOFER PRE OUT
jacks.
0 You can also connect both 78 and 9:. However, you
can only output audio from one of these at a time. When
both are connected, you can switch which speakers to
prioritize. Press
"Other" - "Speakers" to switch between surround back
speakers and height speakers and to switch speakers A
and B.
Setup
0 Settings for the speaker configuration you have
connected need to be made in "1. Full Auto
MCACC" in Initial Setup (P26).
Make sure the exposed speaker cables do not
stick out of the speaker terminals when
connecting. If the exposed wires of the
speakers touch the rear panel or the + and –
wires touch each other, the protection circuit
will be activated.
on the remote control (P6) and use
En 15