Table of Contents
Advertisement
The mounting base attaches to the bottom of the Nortel Networks WLAN - Access Point with
two supplied screws, and then the assembly slides and locks onto two sheet metal, drywall, or
other screws.
•
When you are mounting the Nortel Networks WLAN - Access Point out from a wall (flat sides
along the room or hallway), use the projection-mount L-bracket supplied with the Nortel
Networks WLAN - Access Point. Use the L-bracket to mark the sheet metal, drywall, or other
screw locations.
•
When you are mounting the Nortel Networks WLAN - Access Point against a wall (flat Side A
toward the inside of the building), use the flush-mount bracket supplied with the Nortel
Networks WLAN - Access Point. The flush-mount L-bracket is the one with one long and one
short leg. Use the L-bracket to mark the sheet metal, drywall, or other screw locations.
About Physical Security
Regardless of mounting, the Nortel Networks WLAN - Access Point can be secured with a Kensington
MicroSaver Security Cable. If required, use any MicroSaver Security Cable to attach either side of your
Nortel Networks WLAN - Access Point to a solid beam, pipe, or support.
FCC Statements for Nortel Networks WLAN - Access Points
This section includes the following FCC statements for the Nortel Networks WLAN - Access Point:
•
Class A Statement
•
RF Radiation Hazard Warning
•
Non-Modification Statement
•
Deployment Statement
Class A Statement
Class A Statement
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
RF Radiation Hazard Warning
To ensure compliance with FCC RF exposure requirements, this device must be installed in a location
such that the antenna of the device will be greater than 20 cm (8 in.) from all persons. Using higher
gain antennas and types of antennas not covered under the FCC certification of this product is not
allowed.
Installers of the radio and end users of the Nortel Networks 2200 series must adhere to the installation
instructions provided in this manual.
Non-Modification Statement
Use only the supplied internal antenna, or external antennas supplied by the manufacturer. Unautho-
rized antennas, modifications, or attachments could damage the badge and could violate FCC
regulations and void the user's authority to operate the equipment.
Deployment Statement
This product is certified for indoor deployment only. Do not install or use this product outdoors.
March 16, 2004
FCC Statements for Nortel Networks WLAN - Access Points
About Physical Security
RF Radiation Hazard Warning
Non-Modification Statement
Deployment Statement
FCC Statements for Nortel Networks WLAN - Access Points
27
Advertisement
Table of Contents
