Black & Decker GD300 Original Instructions Manual page 6

ENGLISH
Maintenance and storage
Before use, check the appliance for damaged or

defective parts. Check for misalignment and seizure of
moving parts, breakage of parts, damage to guards and
switches and any other conditions that may affect its
operation. Ensure that the appliance will operate
properly and perform its intended function. Never use
the appliance when any guard or enclosure is damaged
or not in place. Do not use the appliance if any part is
damaged or defective. Do not use the appliance if the
switch does not turn it on and off. Have any damaged or
defective parts repaired or replaced by an authorised
repair agent.
Check the cable frequently for damage. If the cable is

damaged, it must be replaced by an authorised repair
agent in order to prevent a hazard. Inspect extension
cables periodically. Replace a damaged extension
cable immediately.
Keep all nuts, bolts and screws on the appliance tight to

ensure a safe working condition.
Check the grass box for wear or damage and replace

it if necessary. Never use the appliance without the
grass box.
When not in use, the appliance should be stored in

a dry place. Children should not have access to stored
appliances.
Ensure that only replacement cutting means of the right

type are used.
Use only Black & Decker recommended spare parts and

accessories.
Safety of others
This appliance is not intended for use by persons

(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning the use of the appliance by a
person responsible for the their safety.
Children should be supervised to ensure that they do

not play with the appliance.
Warning symbols
The following warning symbols are found on the appliance:
Read the manual prior to operation.
Do not expose the appliance to rain or high
humidity.
6
Keep bystanders away.
Beware of the sharp tines. Tines continue to
rotate after the motor is switched off - remove plug
from mains before maintenance or if the cord is
damaged.
Keep the cable away from the cutting tines.
The tines will continue to rotate after the machine
is switched off.
Electrical safety
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard
Electric safety can be further improved by using a high-

sensitivity 30 mA residual current device (RCD).
Using an extension cable
Always use an approved extension cable suitable for the
power input of this tool (see technical data). The extension
cable must be suitable for outdoor use and marked
accordingly. Up to 30 m of 1.5 mm
cable can be used without loss of product performance.
Before use, inspect the extension cable for signs of damage,
wear and ageing. Replace the extension cable if damaged or
defective. When using a cable reel, always unwind the cable
completely.
Features
1. Grass box
2. Motor cover
3. Switch box
4. Lock-off button
5. Switch lever
Assembly
Warning! Before assembly, make sure that the appliance
is switched off and unplugged.
2
HO5V V-F extension