Advertisement
This step describes how to plug in the cameras and
mounting. Which ever you prefer to do first.
In most cases it is easier to mount the cameras as
long as you know you will have enough cable.
NOTE: Be sure to line up the arrows on both ends
of this connection otherwise the cameras won't
connect and you could damage the pins.
To the right you will see Channel 1 from the DVR
(Male) plugs into the corresponding camera
extension (Female).
The other end of the extension (Male) Plugs into
the pigtail coming from each camera you will need
to line up this connection as well.
NOTE: Line the groves up for a fit. No force.
Lastly, and a very important step is to create a
watertight seal, using the supplied seal, pictured to the
right. Find the How To Video on our website.
Step 6:
Run the power cable to a power source.
Typically the ignition harness under the
driver side steering wheel. Test and make sure
you have a constant power source and a proper
ignition source.
1. Ground (Black)
2. Ignition (Blue)
3. Power (Yellow)
4. N/A
5. Microphone Ground
6. Microphone Power
Make the connection then attach 6 pin to DVR.
Advertisement
