Advertisement
Camera Model: ST-1231
Ensure cameras are properly aimed by adjusting
the 4 screws on both sides of the camera shown
at the right. This camera example, as you can see,
has also been mounted with 3M trim tape.
The bracket attached to this camera is
steel and will allow for screw mounting a
a bit easier.
This camera type is typically placed on
the exterior of a vehicle. Much like the
ST-1252, its weatherproof. In the example to the
right you see it being mounted to achieve an
exterior rear view.
This camera can also be used as a side mount.
Simply by using the hardware supplied in the box.
To the right you will see the hardware required to
adjust the bracket to either side of the camera.
Place the raised plastic mount on the top and the
bottom of the camera, use the small screws to
mount the plastic piece.
Once you have the raised plastic piece mounted
you can fit the bracket and secure with an allen
screw. Finished product shown to the right.
This view is beneficial to capture common side
swipe incidents or to capture blind spots.
Advertisement
