17. ENVIRONMENT CONCERNS ..........32 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler –...
ENGLISH SAFETY INFORMATION Before the installation and use, read this manual carefully: • For your safety and the safety of your property • To help the environment • For the correct operation of the appli- ance. Always keep these instructions with the appliance also if you move or give it to a 1.3 General safety different person.
• Do not install and connect a damaged Electrical connection appliance. • Make sure that the appliance is earth- • Make sure to remove all packaging and transport bolts. • Make sure that the electrical informa- • Make sure that the mains plug is dis-...
Page 5
8 bar (0,8 MPa) Cold water Water supply Maximum load Cotton 7 kg Spin speed Maximum 1400 rpm (L 75470 FL) 1600 rpm (L 75670 FL) 1) Connect the water inlet hose to a water tap with a 3/4'' thread.
3. PRODUCT DESCRIPTION Worktop Feet for the appliance level Detergent dispenser Water drain hose Control panel Water inlet valve Door handle Mains cable Rating plate Transit bolts Drain pump Feet for the appliance level 4. ACCESSORIES Spanner To remove the transit bolts.
ENGLISH 5. CONTROL PANEL Aðalþvottur + Forþvottur Aðalþvottur hljóðlátt Straufrítt Straufrítt + forþvottur Straulétt Viðkvæmt Ull/Silki Kveikt/Slökkt On/Off button (Kveikt/Slökkt) Programme knob Display Start Pause button (Kveikt/Hlé) Delay start button (Tímaval) Time save button (Tímasparnaður) Extra rinse button (Aukaskolun) Stain button (Blettaþvottur) Spin reduction button (Vinding) Temperature button (Hitastig) –...
Page 8
5.3 Display The display shows: • The maximum temperature of the programme. • The default spin speed of the programme. • 'No Spin' and 'Rinse Hold' symbols. • The display symbols. Symbols Description Washing phase Rinse phases Spin phase...
Page 9
ENGLISH • The programme time When the programme starts, the time decreases with steps of 1 mi- nute. • The delay start When you press the delay start button, the display shows the delay start time. • Alarm codes If the appliance has a malfunction, the display shows alarm codes. Re- fer to 'Troubleshooting' chapter.
10 www.aeg.com • To activate the function, press button Spin phase is off. and button at the same time until the display shows the symbol 'Rinse Hold' function is • To deactivate the function, press but- and button at the same time until the symbol goes off.
Page 11
ENGLISH Programme Type of load Cycle Functions Temperature max. weight of description load Aðalþvottur White and coloured Stop with water in STAIN hljóðlátt cotton with normal the drum EXTRA RINSE 95° - Cold soil. Rinses TIME SAVE max. 7 kg Long spin Straufrítt Synthetic or mixed...
Page 12
12 www.aeg.com Programme Type of load Cycle Functions Temperature max. weight of description load Gardínur Set this programme Prewash SPIN REDUCTION 40° - Cold to wash curtains. It Wash RINSE HOLD adds automatically Rinses EXTRA RINSE the prewash phase Short spin to clean the dust from the curtains.
ENGLISH respectively the “standard 60 °C cotton programme” and the “standard 40 °C cotton programme”. They are the most efficient programmes in terms of combined energy and water consumptions for washing normally soiled cotton laundry. Set this programme to have a good washing results and decrease the energy consumption. The time of the washing programme is extended.
14 www.aeg.com Put a small quantity of detergent in temperature without laundry. This the main wash compartment of the removes all possible dirt from the detergent dispenser. Set and start a drum and the tub. programme for cotton at the highest 8.
ENGLISH 10. FILLING THE DETERGENT AND ADDITIVES The detergent compartment for the prewash phase and the soak programme. Add the detergent for prewash and soak before the start of the programme. The detergent compartment for the washing phase. If you use a liquid detergent, put it immediately before you start the programme.
16 www.aeg.com To use powder detergent, turn the flap up. To use liquid detergent, turn the flap down. With the flap in the position DOWN: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid deter- gent than the limit showed in the flap.
ENGLISH 11.1 Interrupt a programme 11.5 Cancel the delay start Press button . The indicator Press button . The related indica- flashes. tor flashes. Press button again. The washing Press button again and again un- programme continues. til the display shows 0’. Press button .
18 www.aeg.com • Press button – The door stays locked. to deactivate the ap- pliance. After five minutes from the – You must drain the water to open the end of the programme, the energy door. saving function automatically deacti- To drain the water: vates the appliance.
ENGLISH • To help the environment, do not use use a water softener for washing ma- more than the correct quantity of de- chines. In areas where the water hard- tergent. ness is soft it is not necessary to use a water softener.
20 www.aeg.com • Use a correct quantity of powder de- Only use special products to remove rust tergent with biological properties. particles from the drum. After each wash, keep the door open for To do this: a while to prevent mould and to let un- •...
ENGLISH Clean the dispenser recess with a brush. Put back the dispenser in the recess. 14.7 Drain pump • The display shows an alarm code be- cause of the problem with water drain. Regularly examine the drain WARNING! pump and make sure that it is Disconnect the mains plug clean.
Page 22
22 www.aeg.com When the container is full of water, put the drainage duct back again and empty the container. Do steps 4 and 5 again and again until no more water flows out from the drain pump. Pull back the drainage duct and turn the filter to remove it.
ENGLISH To clean the water inlet filters: Close the water tap. Remove the water inlet hose from the water tap. Clean the filter in the inlet hose with a stiff brush. Remove the inlet hose behind the appliance. Clean the filter in the valve with a stiff brush or a towel.
24 www.aeg.com 15. TROUBLESHOOTING The start of the appliance does not oc- • - The appliance does not drain cur or it stops during operation. the water. First try to find a solution to the problem • - The appliance door is open or (refer to the table).
Page 25
ENGLISH Problem Possible cause Possible solution The anti-flood de- • Disconnect the appliance. vice is on. • Close the water tap. • Contact the service centre. The spin phase The spin phase is off. Set the spin programme. does not operate. The filter of the drain Clean the filter of the drain pump is blocked.
26 www.aeg.com Problem Possible cause Possible solution The appliance fills The end of the drain Make sure that the drain hose is with water and hose is too low. in the correct position. drain immediately. The washing re- The detergent you used...
Page 27
ENGLISH Remove the cardboard top. Remove the polystyrene packaging materials. Remove the internal film. Open the door. Remove the poly- styrene piece from the door seal and all the items from the drum. Put one of the polystyrene packag- ing elements on the floor behind the appliance.
Page 28
28 www.aeg.com Remove the polystyrene protection from the bottom. Pull up the appliance in vertical po- sition. Remove the power supply cable and the drain hose from the hose hold- ers. Remove the three bolts. Use the key supplied with the appliance.
ENGLISH WARNING! We recommend that you keep Remove all the packaging and the packaging and the transit the transit bolts before you install bolts for when you move the ap- the appliance. pliance. 16.3 Positioning and levelling • Install the appliance on a flat hard floor.
30 www.aeg.com • Connect the water inlet hose to the cold water tap with 3/4 thread. CAUTION! Make sure that there are no leaks from the couplings. Do not use an extension hose if the inlet hose is too short. Con- tact the service centre for the re- placement of the inlet hose.
Page 31
ENGLISH • On the edge of a sink. • Make sure that the plastic guide can- not move when the appliance drains. Attach the guide to the water tap or the wall. • To a stand pipe with vent-hole. Refer to the illustration. Directly into a drain pipe at a height of not less than 60 cm and not more than 100 cm.
32 www.aeg.com 17. ENVIRONMENT CONCERNS Recycle the materials with the appliances. Do not dispose symbol . Put the packaging in appliances marked with the symbol applicable containers to recycle it. with the household waste. Return the Help protect the environment and...