Table of Contents
Advertisement
4. Components
5. Before Using
Make sure that the headsets are fully charged
for at least five hours before initial use.
1. Connect the wall chargers to
Charging Jacks of each headset
(located between the two Volume
Control buttons).
2. While charging, the red indicator
light illuminates. When charging is
complete the light will turn off.
General Instructions
All Headset functions are controlled either by:
•
pushing the Control or Intercom
Button either for a short period of less
than a second or a long period of over
three seconds
or
•
by clicking the volume up and volume
down buttons.
Turning on the Headsets for
the First Time
THE DRIVER UNIT (silver logo): The driver
unit permits two communication modes:
•
Mobile Phone connections with third
parties
•
Intercom connection with the
passenger.
In order for the headset to work with your
cellular phone, they must first recognize each
other. This process is called "pairing", and
only needs to be performed once for each
phone.
1. Turn on your phone and make sure its
Bluetooth function is activated.
2. With the Headset turned off press and
hold the Control Button until the red
and blue indicator lights begin rapidly
alternating.
3. Search for Bluetooth devices on your
phone by following the phone's
instructions.
4. After a few seconds the phone will
list the scala-rider Team-Set as a
discovered device. Select it and
follow your phone's instructions to
accept the pairing.
5. When prompted enter 0000 (four
zeros) as your PIN or passkey.
6. Your phone will confirm that pairing
has succeeded.
Note: If pairing is not completed within two
minutes the headset will return to standby
mode.
Your Headset can pair with up to eight phones,
and will automatically connect to the last
phone connected to the Headset.
Reconnecting the Headset
to a Paired Phone
Although you may have previously paired your
headset to your phone, each time you turn one
of them off, some phones require that you re-
establish the link. Reconnecting may also be
necessary when your headset and phone have
lost the radio signal because the distance
between them has exceeded 30 feet or 10
meters, or major obstacles have come in the
way. After you have turned on your headset
and mobile phone, there are several methods to
re-establish the link if needed:
• Assuming your mobile phone is voice
activation
capable,
headset's CTRL button to activate voice
dial. A signal on your phone's screen will
indicate that the link is re-established.
• Do nothing. Once a call is received, answer
by pressing the CTRL button.
4
press
briefly
the
Advertisement
Table of Contents
