Pioneer PDP 434CMX Operating Instructions Manual page 17

CAUTION
÷ Handles should not be removed or reattached by anyone other
than the professional installation technician or service
personnel.
÷ If handles must be removed due to specific installation
conditions, the mounting screws should be stored carefully
together with the handles. To ensure safety, the mounting
screws should be tightened to a minimum torque of 2N·m (20
kgf·cm) when reattaching the handles.
÷ When moving the display, it should always be carried by two
persons holding the rear handles in the manner shown.
b hole
a hole
b hole
b hole
Rear view diagram (PDP-504CMX)
a hole
b hole
b hole
Rear view diagram (PDP-434CMX)
Air vents (fan)
b hole
a hole
Center line
b hole
Air vents (fan)
a hole
Center line
b hole
Installation and Connections
NO!
÷ Never attempt to move the plasma display by holding only one
of the handles.
÷ When installing the plasma display, do not use the handles as
means of hanging the display; also do not use them as devices
to prevent tipping over (see illustration).
Main unit
Center line
b hole
12 mm to 18 mm (
Side view diagram
Center line
b hole
Attaching surface
Installation
bracket, etc..
a hole
Bolt
12 mm to 18 mm
1 11
( / in. to / in.)
2 16
Bolt
b hole
1 11
/ in. to / in.)
2 16
11
En