Table of Contents
Advertisement
2.
for one minute. (Or use a metal object like a screwdriver to touch the
•
•
an
explosion if
an incorrect model.
• Contact the place of purchase or local dealer if you are not able to replace the
battery by yourself or uncertain about the battery model.
• When installing the
of
negative side
positive
• Used batteries must be handled in accordance with local environmental
regulations.
18) CLR_CMOS (Clear CMOS Jumper)
Use this
jumper
and
reset
defaults. To
screwdriver to touch the two pins for a few seconds.
Open: Normal
Short: Clear CMOS Values
•
Always turn off your computer and unplug the power cord from the
power outlet before clearing the CMOS values.
•
After
system
load
factory
Defaults) or
to
Chapter 2,
configurations).
Chapter
BIOS Setup
2
1.
Turn off your computer and unplug the power cord.
Gently remove the battery from the battery holder and wait
positive and negative terminals of the battery holder,
them
short
3.
Replace
4.
Plug in the power cord and restart your computer.
Always turn off your computer and unplug the power cord
before replacing the battery. Replace the
equivalent
the
battery,
the
positive
(-)
side
should
to
clear
the
CMOS
clear
the CMOS values, use a metal object like a
restart,
go
defaults (select
manually configure the
"BIOS
- 24 -
making
for
5
seconds.)
the
battery.
one.
Danger
of
battery
is
replaced with
note
the
orientation
side
(+)
and
of
the
battery
face
up).
the
BIOS
configuration
values
to
factory
to
BIOS
Setup
Load
Optimized
BIOS
settings (refer
Setup,"
for
BIOS
battery
with
the
(the
to
Hide quick links:
Advertisement
Table of Contents
