AJA KONA 3G Installation And Operation Manual page 29

2k/3g/dual link hd/hd/sd 10-bit pcie card, hdmi 1.4a output

Hide thumbs Also See for KONA 3G:

Table of Contents

KONA 3G Installation and Operation Guide — Installing the KONA Card in a

6. Open the card retainer bar on the left side of the chassis cardcage. Remove the card edge

access cover from the desired slot where you will be inserting the KONA card.

7. Holding the KONA card by the card edge plate and an outside edge, carefully insert the

KONA card by rocking it slowly into the slot. Ensure the card edge aligns properly with

the PC's opening (where the card edge cover was just removed) and that it is fully seated

in the slot.

8. Secure the card in the slot replacing the card retainer bar.

9. Replace the PC's panel/door removed in step 3.

Locate the correct PCIe Slot and Insert the KONA Card (typical installation shown)

Table of Contents