Table of Contents
Advertisement
Installing/Replacing batteries
The device is powered by two AA alkaline or nickel-metal hydride* batteries.
* The device may not function properly due to the discharging characteristics of some nickel-metal
hydride batteries.
CAUTION
Before replacing batteries, make sure that the power is switched "OFF" .
1
Remove the battery compartment cover on the back of the unit, and remove the old batteries.
2
Install the new batteries following the polarity markings in the illustration.
3
Replace the battery compartment cover.
* The indicator lights red when battery power is low. The unit automatically switches off when power
is depleted. Please replace the batteries with a fresh set as soon as possible.
* For more information on battery use, please refer to the "PRECAUTIONS" section (page 3).
Battery cover
About the Auto power off function
In order to prevent unnecessary power consumption, the unit is equipped with an Auto
power off function that automatically switches the power OFF if no signal is detected from
the Instrument jack (
ply slide the power switch to the OFF position and then back to the ON position again
(reboot).
10
EN
Two AA alkaline or nickel-metal
hydride batteries
) for 30 minutes. If the power turns off because of this function, sim-
Advertisement
Table of Contents
