General Information; Vehicle Security Alarm - If Equipped; To Arm The System - Jeep grand cherokee 2018 Owner's Manual

34 GETTING TO KNOW YOUR VEHICLE

General Information

The following regulatory statement applies to all radio
frequency (RF) devices equipped in this vehicle:
This device complies with Part 15 of the FCC Rules and
with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, in-
cluding interference that may cause undesired opera-
tion.
NOTE: Changes or modifications not expressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.
VEHICLE SECURITY ALARM — IF EQUIPPED
The vehicle security alarm monitors the vehicle doors,
hood, liftgate, and the Keyless Enter-N-Go — Ignition for
unauthorized operation. While the vehicle security alarm is
armed, interior switches for door locks and liftgate release
are disabled. If something triggers the alarm, the vehicle
security alarm will provide the following audible and
visible signals:
• The horn will pulse
• The turn signals will flash
• The vehicle security light in the instrument cluster will
flash

To Arm The System

Follow these steps to arm the vehicle security alarm:
1. Make sure the vehicle's ignition is placed in the "OFF"
mode.
• For vehicles equipped with Keyless Entry, make sure
the vehicle's keyless ignition system is OFF.
2. Perform one of the following methods to lock the
vehicle:
• Push the lock button on the interior power door lock
switch with the driver and/or passenger door open.
• Push the lock button on the exterior Passive Entry
Door Handle with a valid key fob available in the same
exterior zone (refer to Doors in Getting To Know
Your Vehicle for further information).
• Push the lock button on the key fob.
3. If any doors are open, close them.