Inside The Box; Ac Power Source; Backup Battery Installation - capello Ci320 User Manual

d. Please note the information printed underneath the unit.
e. Batteries should not be exposed to excessive heat such as direct sunshine, fire,
etc.
f. Do not impede the ventilation of this unit by covering the ventilation openings with
items such as newspapers, table-cloths, curtains, etc.
g. Keep open flames, such as lighted candles, away from this unit.
h. Do not place this unit in closed bookcases, racks, or other spaces without proper
ventilation.
i. Use only the same or equivalent type batteries as there is a danger of explosion if
the incorrect batteries are used or they are installed incorrectly.
j. Dispose of batteries properly according to environmental regulations.

Inside the box

Ci320 Bluetooth Speaker with Clock, AC power adapter and user guide.

AC power source

Insert the small end of the AC adaptor into the DC In Jack (located on the rear of the
unit). Connect the other end to a wall outlet providing 100-240V AC, 50/60Hz.
The output of the provided AC/DC Adaptor is DC 5V 2.5A.
Notes: Disconnect both ends of the power cord when not in use. Use only the
supplied AC adaptor with the following spec.:
AC In – 100-240V AC, 50/60Hz / DC Out – 5V 2.5A
Backup battery
To keep accurate time, this unit uses (2) "AAA batteries" (sold separately) for clock
backup. These batteries keep the clock operating in the event of a power interruption.

Backup battery installation

1. Open the battery door by pushing in on the tabs, then removing the door.
2. Insert two (2) "AAA" batteries following the correct polarity indicated in the battery
compartment.
3. Replace the battery door back on the compartment.
Notes: The batteries are used to backup the clock and alarm times when the AC
adaptor is disconnected or there is a power failure. Alkaline batteries are