Pioneer Elite DV-48AV Operating Instructions Manual page 56

09
Additional information
Problem
Cannot play multi-
channel audio.
Cannot listen to high-
sampling rate audio
through the digital
output.
Cannot output 192 kHz or
176.4 kHz digital audio.
Cannot output 96 kHz or
88.2 kHz digital audio.
No DTS audio output.
Audio mix does not
sound right or sounds
incomplete (for example,
inaudible dialog).
Can't hear effect of
Virtual Surround.
56
En
Remedy
• Make sure that Audio Output Mode is set to 5.1 Channel
(page 45).
• Check that the Dolby Digital, DTS and MPEG Out settings (page 39)
are suitable for your amplifier/receiver — check the instruction manual
that came with your amplifier/receiver.
• DVD-Audio and SACDs do not output multichannel digital audio.
Listen through the player's analog outputs.
• Check that the settings in the Speaker Installation screen are correct
(page 50).
• Check the audio options available from the disc menu.
• Make sure that Linear PCM Out is set to Down Sample Off
(page 39).
• As a copy-protection measure, some DVDs do not output 96kHz
audio. In this case, even if set to Down Sample Off, the player
automatically outputs the audio at 48 kHz. This is not a malfunction.
• The player does not output digital audio at these sampling rates. The
digital output is automatically downsampled.
• Check that Linear PCM Out is set to Down Sample Off (page 39).
• Some discs are digital copy protected and do not output high
sampling rate digital audio. In this case the output is automatically
downsampled.
• If this unit is connected to a non-DTS compatible amplifier or
decoder using a digital audio cable, set DTS Out to DTS
(page 39). If you do not do this, noise will be output when you play a
DTS disc.
• If this unit is connected to a DTS-compatible amplifier or decoder
using a digital audio cable, check the amplifier settings, and that the
cable is properly connected.
• Make sure that Audio Output Mode is set to 2 Channel if you've
connected to the stereo inputs on your amplifier or TV (page 45).
• Virtual Surround does not work with SACD or DVD-Audio.
• The Virtual Surround effect is only output through the AUDIO OUT
(2ch) analog audio outputs.
• Make sure that Audio Output Mode is set to 2 Channel (page 45).
• The effectiveness of Virtual Surround varies with the disc.
>
PCM