Installation; Opening The Switcher - Extron electronics ISS 506 Installation Manual

Installation

im Vertrieb von
The ISS 506 can be modified to install or remove optional boards that change the input and/or output formats that
the switcher can process. The following optional I/O boards are available:
SDI/HD-SDI input
•
Scan converter (low resolution) output
•
• HD-SDI output
DVI output
•
Modify the ISS by performing the procedures in the following sections, as applicable:
1

Opening the Switcher

2
Installing an Optional SDI/HD-SDI Input Board
3
Installing an Optional Output Board
4
Closing the Switcher
Opening the Switcher
Extron recommends that you send the unit in to Extron for service and updates.
N
To replace or install an optional input or output board, you will need to open the ISS's case. Open the switcher as
follows:
1. Disconnect the AC power cord from the ISS to remove power from the unit.
W
2. If the ISS is installed in a rack, disconnect all signal and control cables and remove the ISS from the rack.
www.camboard.de
ISS 506 Optional I/O board • Installation
CAMBOARD Electronics
To prevent electric shock, always unplug the ISS from the AC power source before opening the enclosure.
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de