Operating Instructions - Guardian AC5300 series Use & Care Instructions Manual

INSTALLING & REMOVING COMbINATION FILTER
The Air Cleaner will beep for 30 seconds and the Replace HEPA light will flash
REPLACE
HEPA continuously indicating that it is time to replace your filter. Replace the filter
according to directions then restart the system. See specific model instructions
(E-7/E-8). Depending on usage, filter will last approximately 6 months.
1. Turn off and unplug the unit.
2. Press the Lock & Release 3. Remove the used
Button and remove the Combination Filter (Filter C)
Rear Cover from the unit. and dispose of it in
the garbage.
5. Reattach the Rear Cover of the unit and securely latch into place.
Check out our
Filter Replacement Program
www.guardiantechnologies.com
Check out our on-line Filter Reminder
and Replacement program.
www.guardiantechnologies.com
E-6
SPEED
4. Insert filter system into the unit.
Consult the arrow on the filter
for correct installation direction.
SPEED
™

OPERATING INSTRUCTIONS

bEFORE OPERATING THE AIR PURIFIER:
1. Select a firm, level and flat location for the air purifier.
* For proper air flow, locate the unit at least 1 foot from any wall or furniture.
* Make sure none of the grills are blocked.
2. Plug the power cord into a 120V AC outlet.
IMPORTANT
: When moving the air purifier, always lift unit by the carrying handle located
on back.
OPERATING THE AIR PURIFIER (AC5300 SERIES):
UV
1. Turn unit power ON. To turn OFF, press and hold button for 3 seconds.
SPEED MODE
HEPA / UV RESET
HOLD 3 SECONDS TO RESET
2. Select fan speed MODE 1 - 3
REPLACE
UV
1 = low, ultra quiet sleep mode
HEPA
3 = high
UV
3. Select UV-C ON or OFF using UV-C Mode Button.
MODE
HEPA / UV RESET
HOLD 3 SECONDS TO RESET
*Filter Replacement Indicator: The Replace HEPA light on the control panel will
UV
MODE
illuminate and flicker indicating that it is time to replace your filter. Replace the filter
HEPA / UV RESET
according to directions (E-6) then press and hold the UV Mode button for 3 seconds to
HOLD 3 SECONDS TO RESET
reset the system.
*UV bulb Replacement Indicator: The circular blue light on the front panel of the purifier will
flicker when it's time to replace the bulb. Replace the bulb according to directions (E- 8), then press
and hold UV Mode button for 3 seconds to reset the system.
E-7