Removing The Front Unit - JVC KD-ADV5380J Service Manual

3.2.6 Removing the front unit

(See Fig.10 to 12)
• Remove the top cover and the mechanism section.
(1) Disconnect the flexible wire from connector
mechanism control board at the bottom of the body. (See
Fig.10.)
(2) Remove the screw G attaching the front unit on the top of
the body. (See Fig.11.)
(3) Move the front unit toward the front to release joint h, and
release two joints i and j on the right side of the chassis
base assembly. Then remove the front unit upward. (See
Figs.11 and 12.)
(4) Remove the two screws H attaching the switch board. (See
Fig.12.)
Reference:
You can remove the switch board only without removing the
front unit.
Caution:
When reassembling, attach the flexible wire extending from
the switch board using the double tape. (See Figs.10 and 12.)
Mechanism control board
Double tape
CN202
1-20 (No.MA308)
CN202
Flexible wire
Fig.10
on the
Double tape
j
i
G
Front unit
h
Fig.11
H
Switch board
G
Front unit
h
Fig.12