Pioneer DEH-P900HDD Operation Manual page 71

S
etting the FM tuning step
Normally, the FM tuning step is set at 50 kHz
during seek tuning, however, it changes to 100
kHz when the AF or TA function is on.
You can set the FM tuning step to 50 kHz even
when the AF or TA function is on.
1. With the source turned off, press and
hold 1.
2. Press NEXT and then press FMstep to
select the FM tuning step mode.
3. Press the corresponding button to select
the desired tuning step.
Button Tuning step
50K 50 kHz
100K 100 kHz
Note:
• The FM tuning step remains set at 50 kHz during
manual tuning.
• The tuning step returns to 100 kHz if the battery is
temporarily disconnected.
S
etting the warning tone
The warning tone sounds to remind you to
detach the front panel. (Refer to page 11.)
You can turn the warning tone function on or
off.
1. With the source turned off, press and
hold 1.
2. Press NEXT and then press DT-WRN to
select the warning tone mode.
3. Press DT-WRN to turn the warning tone
on.
"ON" appears in the display.
• Press DT-WRN again to turn the warning
tone off.
70