Summary of Contents for Samlexpower VTC605-12-12
- Page 1 DC to DC Owner's Please read this manual before Manual Step Up operating your converter Converter Model: VTC605...
-
Page 2: Specifications
12 and 24 VDC power systems in marine, automotive or aeronautical environments and more. SPECIFICATIONS Model VTC605-12-12 VTC605-12-24 10.5 - 18 VDC 10.5 - 28 VDC Input Voltage Input –... -
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS — This manual contains important safety and operating instructions for the converter. ALL CONVERTERS 1) CAUTION — To reduce risk of injury, charge only lead acid or sealed gel cell type rechargeable batteries. Other types of batteries may burst causing personal injury and damage. -
Page 4: Installation
INSTALLATION MOUNTING Mount the unit in a DRY location. Allow at least 1 inch of clearance for adequate cooling. POWER CONNECTION The unit is supplied with three foot power input leads. This should normally be adequate to connect to a source of power. If you must extend the cable: •... -
Page 5: Operation
OPERATION Turn the power switch on the front of the unit on to energize the outputs. To adjust the output voltage, turn off the power switch. Remove the plate from the top of the box. Reach in with a non-conductive device such as a pencil and open or close the dip switches as shown below to select the desired output voltage. - Page 6 Dry Contact Relay To use your dry contact output fail relay you must connect a 9-pin D connector to the unit. You must use pins one and six as is indicated on page 6 in the remote connector diagram. The relay is factory preset to fail in the closed position when the low output LED and buzzer come on.
-
Page 7: Remote Control Option
REMOTE CONTROL OPTION A remote control panel may be connected to the con- verter using a 9-pin D-connector, which attaches to the side of the converter. The remote control panel and D connector are part of the remote control option. The remote control panel allows the unit to be oper- ated remotely as well as duplicating all the diagnostic indicators and audible alarm.