Features And Controls - Briggs & Stratton 030653-00 Operator's Manual

Features and Controls

Read this Operator's Manual and safety rules before operating your generator.
Compare the illustrations with your generator, to familiarize yourself with the locations of various controls
and adjustments. Save this manual for future reference.
A
B
C
D
E
F
G
H
J
A - Fuel Tank Cap Vent Lever — Turn the vent lever
to the ON (I) position when operating generator.
Turn to the OFF (0) position when not in use.
B - Fuel Tank — Capacity of 3.7 L (1.0 U.S. gallons).
C - Choke Lever — Used when starting a cold engine.
D - Side Maintenance Cover — Remove to gain
access to the air cleaner and oil service.
E - Recoil Starter — Used to start the engine
manually.
F - Engine Switch — Set this switch to ON (I) before
using recoil starter. Set switch to OFF (0) to stop
engine. Also turns fuel valve on and off.
G - Output Indicator — A green LED light comes
on when the generator is working correctly and
producing power at the receptacles.
H - 12 Volt DC Receptacle — Use this receptacle
with battery charge cables to charge a 12 Volt
battery. This receptacle is protected by a push to
reset circuit breaker.
J - Grounding Fastener — Consult your local agency
having jurisdiction for grounding requirements in
your area.
K - POWERSMART Switch— Use this switch to turn
the POWERSMART mode on and off.
12
L - Overload Alarm — A red LED light comes on and
cuts power to the receptacles when the generator
is overloaded.
M - Low Oil Indicator — A yellow LED light comes on
when the oil in the generator drops below a preset
level.
N - 230 Volt AC, 15 Amp Receptacles — May be
used to supply electrical power for the operation
of 230 Volt AC, 15 Amp, single phase, 50 Hz
electrical, lighting, appliance, tool, and motor loads.
P - Spark Arrester Muffler — Exhaust muffler lowers
engine noise and is equipped with a spark arrester
screen.
R - Top Maintenance Cover — Remove to gain
access to the spark plug.
Items Not Shown:
Air Cleaner (under side maintenance cover) —
Protects engine by filtering dust and debris out of
intake air.
Identification Label — Provides model, revision, and
serial number of generator. Please have these readily
available when calling for assistance.
Oil Fill Cap (under side maintenance cover) —
Check and add engine oil here.
www.briggsandstratton.com.au
R
P
N
M
L
K